CreaZyme Neutral MAX            

Knitted cloth smoothing and finishing enzyme preparation

CreaZyme Neutral MAX is a neutral polishing enzyme for finishing of knit fabrics. It can be used in one bath in the enzymatic polishing process and dyeing process by saving time, water, energy and significantly reducing production costs while ensuring the production of high quality products.

ADVANTAGES

Simplified process

l Maximize fabric strength and reduce weight loss

l Significantly reduce process time and increase productivity

l Can effectively remove dead cotton

l It can be used for dyed fabrics.

l Can be used under a wide range of pH conditions without special time adjustment of pH.

l Save costs over 30% which can be achieved with optimized processes

USER'S GUIDANCE

CreaZyme Neutral MAX can be used on all overflows, spray and other mechanically agitated wet processing equipment.
CreaZyme Neutral MAX is easy to operate, can be synchronized with dyeing, and can be used before or after dyeing as with conventional acid polishing enzymes. It can also be used in parallel with other biological processes such as bio-deoxidation, bio-refining, etc. to achieve cost optimization.
When CreaZyme Nuetral MAX is dyed in the same bath, it is added at the beginning of the dyeing process after bleaching and deoxidation. Before adding CreaZyme Nuetral MAX, first adjust the pH and temperature to meet the dyeing requirements. After adding CreaZyme Neutral MAX, run for 10-20 minutes to make it evenly, add dye or salt. Perform a normal dyeing process. Subsequent addition of alkali is inactivated by polishing enzyme.

PROCESS CONDITIONS

Chemical additives：Nonionic wetting agents and increase the rate of dispersion.
The efficacy of strong enzyme preparations.

DOSE GUIDE

Factors affecting biological finishing include：

• Fabric composition, structure and weight
• Expected effect
• Processing time, pH and temperature
• Chemical additives
• Type of equipment and mechanical friction

Type of product  Recommended dosage O.W.F

     Fabric          Not more than 0.5%    

 INACTIVATION OF ENZYME

Once the desired effect is achieved, all cellulose should be inactivated. Incomplete deactivation can result in excessive exposure of the garment or fabric to the active cellulose, causing unnecessary fabric strength damage.

Neutral cellulose MAX can be inactivated by any of the following methods：

A.   The working solution was maintained at a pH greater than 9.0 and a temperature greater than 600 ℃ for 15 minutes. The pH can be adjusted with soda ash (sodium carbonate) or borax; or

B.   Add enough alkaline detergent to bring the pH above 9.0. Hold for 15 minutes at temperatures above 60℃.

 STORAGE

To extend product life, the neutral cellulase is stored in a sealed container at a temperature of 250 ℃(770℉) or below. Long-term exposure to high temperatures can cause inactivation.

SAFETY AND ENZYME MANAGEMENT

Avoid inhaling dust from enzymes. Rinse immediately with water for at least 15 minutes if it comes into contact with your skin or eyes.